Note
Access to this page requires authorization. You can try signing in or changing directories.
Access to this page requires authorization. You can try changing directories.
This test verifies that the bezel around the touchpad meets the requirements.
Test details
Associated requirements |
Device.Input.PrecisionTouchpad.Hardware.Bezel System.Client.PrecisionTouchpad.PrecisionTouchpad |
Platforms |
Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86 |
Expected run time |
~2 minutes |
Categories |
Certification |
Type |
Manual |
Running the test
Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.
If the touchpad surface is at all above the surrounding casing of the touchpad, press F fail the test. Else, move to the next step.
Place a 1.5mm wide piece of plastic (or other non-conductive material) on the surface of the touchpad, such that the plastic does not touch the surrounding casing of the touchpad.
- If the touchpad and the plastic is lower than the surrounding casing, press F to fail the test. If the touchpad surface is anywhere, press P to pass.
Troubleshooting
For troubleshooting information, see Troubleshooting Device.Input Testing.
More information
Command syntax
| Command | Description |
|---|---|
ptlogo.exe Test.DeviceBezel.json |
Runs the test. |
File list
| File | Location |
|---|---|
ptlogo.exe |
<testbinroot>\input\PrecisionTouchpad\ |
config.json |
<testbinroot>\input\PrecisionTouchpad\ |
Test.DeviceBezel.json |
<testbinroot>\input\PrecisionTouchpad\ |